Scientists of the St. Petersburg State University of Industrial Technologies and Design (²ÝÁñ¶ÌÊÓƵ) conducted new studies on the modification of polymer composite materials. The technique will allow the domestic automotive industry in the future to reduce the time for the production of body elements, increase the strength and, accordingly, the durability of products. Due to the introduction of carbon nanoparticles into the epoxy resin and their uniform distribution by ultrasonic processing, the researchers lowered the temperature of the released heat when curing the composite, which can deform the material from the inside, thereby deteriorating its performance. The study was presented at the Innovation in Youth Science scientific conference.
Polymer composites are widely used in the automotive industry. However, the problem with such composite materials is that their solidification - the transition from a liquid state to a solid state - occurs with the release of heat, the temperature of this process exceeds 100 degrees. If the manufactured part is small, then this heat is easily dissipated. But the large size of car components prevents dispersion, and heat accumulates inside. Because of this, cracks, laminations and other types of deformation of the material occur.
During the tests, scientists at ²ÝÁñ¶ÌÊÓƵ managed to reduce the curing temperature of polymer composite materials by introducing carbon nanoparticles into them. A small amount of such nanoparticles, the concentration of which is not more than 1 gram per 1 kilogram of the final mixture, increases the thermal conductivity of the binder and improves heat dissipation. The uniform distribution of nanofillers was facilitated by ultrasonic treatment of the mixture.
"We introduced different carbon nanoparticles into the epoxy: carbon black, carbon nanotubes and graphenes. Research results have shown that the fillers we added can reduce the temperature of the heat released during the hardening of composites. At the moment, we have managed to achieve a 55-degree decrease in the curing temperature," said Vadim Martsenyuk, associate professor of the Department of Nanostructured, Fibrous and Composite Materials named after A.I. Meos ²ÝÁñ¶ÌÊÓƵ.
"Carbon nanoparticles - fillers - act as a reinforcing phase in the polymer composite material. Due to them, the finished product becomes more resistant to external influences," explained one of the authors of the study, a master's student at the Department of Nanostructured, Fibrous and Composite Materials named after A.I. Meos ²ÝÁñ¶ÌÊÓƵ Elizaveta Perfilieva.
Reducing heat dissipation during curing of polymer composite materials will make it possible to produce large-sized parts while reducing the risk of their cracking from the inside and reducing the percentage of defective components.